M4 BZO TARGET PDF

FOR ZEROING AT 25 METERS, ROTATE THE REAR SIGHT ELEVATION KNOB TO THE METER (6/3) SETTING. (DO NOT USE THE “Z” MARK ON THE. DOD-M4 25 Meter Zeroing Target M-4 Carbine Official Military Target /4″ X 11″ Tag Target Paper Box of M4 Carbine. M16A4. M16A2. For every yards of range from the target, one (1 ) click will move the strike of the bullet on the target approximately: OBJECTIVE.

Author: Zolodal Daitaur
Country: Timor Leste
Language: English (Spanish)
Genre: Career
Published (Last): 15 September 2007
Pages: 463
PDF File Size: 4.69 Mb
ePub File Size: 4.2 Mb
ISBN: 575-4-42886-272-5
Downloads: 98252
Price: Free* [*Free Regsitration Required]
Uploader: Vohn

Reply Your comment will be posted after it is approved. I’ve seen these offered on 8.

M4 Carbine – 25 Meter Zeroing Target

These instructions are for iron sights only as the point of impact POI for optical sights will vary. The sight radius on an M16A2 is Instead set targe rear sight to the horizontal line under the m setting on your BUIS. Sarge40 on August 25, Excellent target. Anyway, while I can get my hands on the Army zero sheets I wanted to see what was available on line. Kevin O’Day on December 15, See if you can hit what you’re aiming at! Flipper on August 16, I’m late on answering this.

  LEON DUFOUR VOCABULARIO DE TEOLOGIA BIBLICA PDF

Could not find this target anywhere in San Angelo, Texas. taregt

I can’t believe this is available! M4 Carbine – 25 Meter Zeroing Target.

Target – M4 Carbine – 25 Meter Zeroing Target | Print Free Targets

That seems to be a bit small for a 25 meter target. It is funny though because Army and Marine vary slightly.

I think there might be an error in the first, and third step of your instructions. Make sure the BUIS is flat on the tarfet rail with the angled edge under the upper receiver rail. The extra click is definitely for mechanical zero.

To zero M16A4 Rifle, turn the knob until the line on the sight cam on the left side is aligned with the white line between the and marks. The BUIS must be mounted in the rearmost slot on the upper receiver for the range adjustments and the zeroing procedures to be correct. When standard zeroing procedures are followed, a properly zeroed weapon for one person is close to the zero for another person for that specific rifle.

Do not over tighten. M16A2 and M4 meter zero target. It’s usually differences in fundamentals applied among individual shooters that cause the variations in a zero trget the same rifle. This is a “mechanical zero” and should never reay be adjusted its much more efficient to implement Kentucky windage for closer targets.

  ASTM C426 PDF

This sheet was pretty accurate. When using the meter mark too zero at 25 meters will the sights be on target at meters? Zero m44 data for the M4 Carbine: What is the optimal distance between front and back sight?

The Recoil Screw has a locking patch on the threads targer it must be replaced if removed. This target is the real deal! Sarge 40 on August 25, We use this target to train new recruits on sighting AR platform patrol rifles. I’m late on answering this.

MATECH Backup Iron Sight (BUIS) Mounting and Zero Instructions – NOBLECO TACTICAL

This mark is a half notch location, so it’s more difficult to align. Zeroed hundreds of weapons. Adjust the sights to move the shot group center as close as possible to the white dot in the center of the target. Iron sight buis pm nsn