Europastandarden EN gäller som svensk standard. The European Standard EN has the status of a Swedish. Standards. DIN EN Safety of industrial trucks – Pedestrian propelled manual and semi-manual trucks – Part 3: Platform trucks; German version EN. DIN EN Safety of industrial trucks – Pedestrian propelled manual and semi-manual trucks – Part 3: Platform trucks.
|Published (Last):||1 October 2010|
|PDF File Size:||13.64 Mb|
|ePub File Size:||11.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
General requirement for battery powered trucks Part 2: The maximum steering force EBmax is the average ej the recorded measurements on the left hand side G and on the right hand side D. It is the constant aim of BSI to improve the quality of our products and services.
BS EN 1757-3:2002
During measurement the force continues to be applied tangentially, the wheels swivel freely and are turned crosswise at the end of the measurement. The hand grips shall be of a cross section enclosed within the space between two concentric circles of 25 mm inside 177-3 and 35 mm outside diameter. Chariots a conducteur a pied manuels et semi-manuels. This website is best viewed with browser version of up to Microsoft Internet Explorer 8 1757–3 Firefox 3.
This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. Compliance with a British Standard does not of itself confer immunity from legal obligations. BS EN Safety of industrial trucks — Self-propelled trucks up to and including 10 kg capacity and industrial tractors with a drawbar 175-3 up.
Hazards Corresponding requirements 4. Industrial trucks, Materials handling equipment, Hand trucks, Equipment safety, 177-3 engineering, Commercial road vehicles, Pedestrian-controlled systems, Platforms, Hazards.
Learn more about the cookies we use and how to change your settings. In case of e operation, the truck shall be adapted until the test is successful.
BS EN Safety of industrial trucks – MBA智库文档
ENRoll containers. During measurement the lower surface of the tiller handle shall be maintained at a height of mm above the ground.
The efforts shall be measured in accordance with the methods described below for all the values of load indicated in Table 1 which are less or equal to the rated capacity and located according to 6.
Revisions British Standards are updated by amendment or revision.
Two tests in both the forward and reverse directions shall be carried out and the average result recorded. Worldwide Standards We can source any standard from anywhere in the world.
The test shall be carried out with a new truck chosen according to 6. Vertical bars shall have a vertical length of at least mm. Search all products by. A series of longitudinal and lateral stability tests shall be carried out depending on the truck type with the positions of the truck on the platform as below and Table B.
The force to push the truck shall cease when the truck hits the obstacle Figure B. The same test shall be carried out when pulling. The corresponding requirements are designed to limit the risk or reduce these hazards in each situation. Various BSI electronic information services are also available which give details on all its products and services.
BS EN – Safety of industrial trucks. Pedestrian propelled trucks. Platform trucks
This publication does not purport to include all the necessary provisions of a contract. You may experience issues viewing this site in Internet Explorer 9, 10 or The truck shall be examined visually to ensure that there are no defects. For dated references, subsequent amendments to or revisions of any of these publications apply to this European 177-3 only when incorporated in it by amendment or revision.
The hand grips shall be of 7157-3 cross section enclosed within the space between two concentric circles of 25 mm inside diameter and 35 mm outside diameter and provide a minimum span of mm for each hand.
The centre of gravity of the load on each level shall be on the centre line of the truck and mm above the geometrical centre of the platform or the shelf 3. The BSI copyright date displayed in this document indicates when the document was last issued.